MODINE Unit Heater, Series: PDP, 240000 Btu/hr, 115 V, 1053 fpm Flow Rate, 4460 cfm Rating, 1/2 hp, 1 ph, 60 Hz, 3/4 in Connection, LP, Natural Gas Fuel, 22 in Fan, Permanent Split Capacitor Motor, Intermittent Pilot Ignition, Horizontal Mounting, 21 ft Mounting Height, 74 ft Heat Throw, Steel, Aluminized/Baked-On Polyester Powder-Painted, 40-1/4 in H x 28-5/8 in W x 34-3/4 in D
- 80% thermal efficiency, maximizing seasonal efficiency through the use of a collector box and the power exhauster
- A power exhaust that can be rotated 180 deg, the unit can be vented vertically or horizontally
- A 100% shut-off, intermittent pilot-ignition system with continuous retry, at no extra charge, this ignition system allows for all PDP/BDP units to be field-converted to propane, if desired
- A safety pressure-switch to assure safe venting conditions
- Designed to utilize the smallest-diameter vent pipe possible
- Wing screws so that the bottom pan can be dropped without a screwdriver or nut driver
- A levels hanging mechanism for easy field adjustments after adding accessories that may change the unit's centre of gravity
- Aluminized steel heat exchanger/burner
- A automatic reset vent pressure switch is supplied on all power vented unit heaters to prevent operation of the main burner in the event there is restricted venting of flue products
- All power vented unit heaters are supplied with a round vent pipe connection, power exhauster may be rotated 180 deg to allow for various venting directions
- The PDP (propeller) high efficiency II gas-fired unit heaters are a generation of products that are inexpensive to install, easy-to-use and offer excellent in-service economy
BTU Rating |
: |
300000 Btu/hr Input, 240000 Btu/hr Output |
CFM Rating |
: |
4460 cfm |
Connection Type |
: |
3/4 in Gas |
Dimensions |
: |
28-5/8 in W x 40-1/4 in H x 34-3/4 in D |
Fan Size |
: |
22 in Dia |
Finish |
: |
Baked-On Polyester Powder-Painted |
Flow Rate |
: |
1053 fpm |
Frequency Rating |
: |
60 Hz |
Fuel Type |
: |
Natural Gas, LPG |
HP Rating |
: |
1/2 hp |
Heat Throw |
: |
74 ft |
Ignition Type |
: |
Intermittent Pilot |
Material |
: |
20 ga Aluminized Steel |
Motor Type |
: |
PSC |
Mounting Height |
: |
21 ft Maximum |
Mounting Type |
: |
Horizontal |
Phase |
: |
1 |
Series |
: |
PDP |
Voltage Rating |
: |
115 V |