MODINE Unit Heater, Series: PDP, 160000 Btu/hr, 115 V, 5.15 A, 819 fpm Flow Rate, 2870 cfm at 70 deg F CFM Rating, 1/6 hp, 1 ph, 60 Hz, 1/2 in Connection, Natural Gas Fuel, Permanent Split Capacitor Motor, 1075 rpm Rotational Speed, Intermittent Pilot Ignition, Vertical Mounting, 15 ft Mounting Height, 51 ft Heat Throw, Steel, Aluminized/Baked-On Polyester Powder-Painted, 40-1/4 in H x 25-5/8 in W x 34-3/4 in D
- 115 V service/25 V thermostat, one-stage control system
- 100% shut off, intermittent pilot ignition with continuous retry
- 20 in Dia fan
- 80% thermal efficiency, maximizing seasonal efficiency through the use of a collector box and the power exhauster
- A power exhaust that can be rotated 180 deg, the unit can be vented vertically or horizontally
- A safety pressure-switch to assure safe venting conditions
- Designed to utilize the smallest-diameter vent pipe possible
- Wing screws so that the bottom pan can be dropped without a screwdriver or nut driver
- A levels hanging mechanism for easy field adjustments after adding accessories that may change the unit's centre of gravity
- Aluminized steel heat exchanger/burner
- A automatic reset vent pressure switch is supplied on all power vented unit heaters to prevent operation of the main burner in the event there is restricted venting of flue products
- All power vented unit heaters are supplied with a round vent pipe connection, power exhauster may be rotated 180 deg to allow for various venting directions
- The PDP (propeller) high efficiency II gas-fired unit heaters are a generation of products that are inexpensive to install, easy-to-use and offer excellent in-service economy
Amperage Rating |
: |
5.15 A |
BTU Rating |
: |
200000 Btu/hr Input, 160000 Btu/hr Output |
CFM Rating |
: |
2870 cfm at 70 deg F |
Connection Type |
: |
1/2 in Gas |
Dimensions |
: |
25-5/8 in W x 40-1/4 in H x 34-3/4 in D |
Finish |
: |
Baked-On Polyester Powder-Painted |
Flow Rate |
: |
819 fpm |
Frequency Rating |
: |
60 Hz |
Fuel Type |
: |
Natural Gas |
HP Rating |
: |
1/6 hp |
Heat Throw |
: |
51 ft |
Ignition Type |
: |
Intermittent Pilot |
Material |
: |
20 ga Aluminized Steel |
Motor Type |
: |
PSC |
Mounting Height |
: |
15 ft Maximum |
Mounting Type |
: |
Vertical |
Phase |
: |
1 |
Rotational Speed |
: |
1075 rpm |
Series |
: |
PDP |
Voltage Rating |
: |
115 VAC |