The two zone horizontal ComfortPLENUM™ with bypass damper is 21 in x 21 in x 3 ft long. Installers simply cut a circular hole in the sheet metal using the cutting guide decal to choose the size of their hole from 6 to 16 in round or rectangular. The cutting guide is located on the sheet metal directly in front of the damper. The damper is mounted on the inside of the plenum directly behind the cutting guide. Once the hole is cut and the insulation is trimmed away, the damper blades will be showing. Duct-tab or spin-in starting collars may be installed into the holes. The two zone plenum has three dampers, one is placed on each (as shown). However, the plenum may be rotated 90 deg so that one zone damper is on the top and one is on the bottom position to avoid framing, maintain better air flow or other reason that is beneficial to the application. Also, in applications where equipment is above removable ceiling tile, the plenum can be rotated 180 deg so that the motors are accessible from the bottom. The third damper is on the endcap and is usually used as the bypass damper, but it does not have to be. In this application the bypass damper modulates to maintain the correct pressure in the plenum.

Comfort PRODUCTS Horizontal Duct Plenum, Sheet Metal, 3 ft Length, 21 in Width, 21 in Height

• Works with most zoning systems
• 2 in duct liner, glued then pin-spotted
• Dampers with power open/power close motors
• Adjust motors to any maximum and/or minimum position
• Includes damper for modulating bypass
• Cutting guide allows from 6 in through 16 in round holes for duct take-offs
• Cutting guide allows up to a 16x16 in rectangular opening for duct take-offs
• Damper motors include red and green LED's to indicate opening, closing, full open or full close
• All damper blades are gear-driven using opposed blade action for even airflow
• 1/2 in gasket material adds extra insulation to the damper gear box